Welcome to the staging ground for new communities! Each proposal has a description in the "Descriptions" category and a body of questions and answers in "Incubator Q&A". You can ask questions (and get answers, we hope!) right away, and start new proposals.
Are you here to participate in a specific proposal? Click on the proposal tag (with the dark outline) to see only posts about that proposal and not all of the others that are in progress. Tags are at the bottom of each post.
How do I draw a perfect circle on a square of plywood? Question
I'm working on a string-art project on a 3-ft square of plywood. It will have brass nails in a circle with different colors of string connecting the nails in a pattern.
I'm trying to figure how I can draw large enough circle on the plywood. I've thought about:
- Finding a bowl to trace, but none in my house are large enough.
- Using a compass, but again, mine isn't large enough.
- Freehand drawing the circle, but it comes out too imperfect.
2 answers
You are accessing this answer with a direct link, so it's being shown above all other answers regardless of its score. You can return to the normal view.
When I needed to cut a 4' circle out of the middle of a sheet of plywood, I fabricated a compass by tying a long-enough piece of non-stretchy string to a tack or finishing nail -- I forget which, but it was something small enough that it wouldn't leave a mark on the other side of the plywood.
To the other end of the string I tied a pencil at the desired radius. Working on the side of the plywood that I designated as the back, I found the center point by measuring, drove in the tack, had a friend hold it in place just in case, and walked around the board tracing the line with the pencil. Tip: do this at sawhorse or table height; you want to be able to walk around it and maintain consistent tension while doing so, not crawl around on the floor.
Measure twice, cut once: after I had a line I could see, I measured the diameter in a few places to convince myself that any variability was within the margin of error that cutting it out with a jigsaw would produce. (Maybe there were better ways to cut it, but a jigsaw is what I had.)
2 comment threads
There's a few ways to do it:
- Use a compass. I know you said yours is too small, but you can buy a carpenty or woodworking compass that is much larger (foot or more).
- Tie a string to your pencil, keep one end of the string fixed with your finger or something else (toothpick, nail, other pencil) while you rotate the pencil while keeping string taut.
- Fix the center of the plywood (for example, by pinning it down with a nail), hold the pencil in place, and rotate the plywood.
And, one for fun more than practicality: Hang a flashlight above the plywood. It will probably make a circular pattern that you can trace. You can vary the radius by adjusting the height.
0 comment threads